Enjoy Sonic Sound with the Crest Audio Pro 9200 Professional Power Amplifier
If a professional power amplifier with incredible sonic integrity is what you’re after, you should check out the Crest Audio Pro 9200 Professional Power Amplifier. It delivers the sonic integrity that is the hallmark of Crest.
This professional power amplifier is encased in a compact 2U package that weighs under twenty-five pounds. It’s hard to believe all the power that comes in a small package and a low cost. The Crest Audio Pro 9200 protects connected drivers with automatic clip limiting.
The 2100 Watts per channel will make it possible to really blast people out of a room. The specifications of the Pro 9200 are very similar to its predecessors, the amps in the Pro 200 series. All pro series amplifiers have a frequency response that is within 0, -3 dB from 10 to 100 kHz, with hum and noise greater than -110 dB, “A” weighted. The input impedance is 15 k Ohms, balanced.
The IGM impedence sensing will automatically modify the gain to accommodate any of the impedence outputs that are connected. The real beauty of IGM is the short circuit protection as well as loads as low as 2 Ohms and highly efficient operation.
The Audio Pro 9200 has a range of special features such as high efficiency heat sinks that are tunnel cooled and DC fans with variable speed that is designed to extend the life of the amplifier by limiting the operating temperature. It doesnt take long to realize that this professional power amplifier can really crank up the volume with the latest generation of high speed, wide-band width output devices and a host of features, some that help to enhance Crests sonic integrity.
The air temperature of the Audio Pro 9200 is automatically measured with a temperature sensing system. The air is the funneled to the exhaust on the front panel with rear mounted fans. If the temperature were to exceed the safe operating limits, one on the channels will automatically shut down. When sound is blasting at these levels, everyone and everything will be affected the by products of the heat.
Input connections on the rear panel are via XLR and actively balanced. There are binding post and Speak on output connections per channel to connect to the loudspeaker. The input attenuators and combination AC power switch/circuit breaker are located on the front panel of the amplifier.
The five LED’s per channel on the front panel will indicate ACL, signal and temperature protect, Active, and DC protect. The rear panel features a mode switch that will determine bridged mono, stereo, or parallel mode. The gain select switch is also located on the rear panel and will determine if the structure is x20 or x40. The Crest Audi Pro 9200 professional power amplifier is very impressive. While you will be able to blast your neighbors out of their beds, be careful. You don’t want to blow speakers on a piece of equipment that runs around $2000.
Discussion Area - Leave a Comment
You must be logged in to post a comment.